Tweet
I need a nice 46 or 47 bull neck frame, with side car hoops and steering head forging un-molested, tank mounts etc not too critical. Also need a set of cylinders five fin FL. with another few miles left. No sleves. Already have a set with loose sleves. Have a line on a single front ? cylinder but not sure if it's any good, so will look at single rear. Thanks, Bob 970-209-6472
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here