Announcement

Collapse
No announcement yet.

Fly Wheel Balncing Stand

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Fly Wheel Balncing Stand

    Before I attempt to make my own, I thought I'd ask. I am looking for a flywheel balancing stand that I could use with rods and pistons thus a little deeper than your typical Harley truing stand - at least the ones ive seen,
    thanks
    Dan

  • #2
    I made my truing stand but did not figure the height to allow balancing,so now I clamp the stand on its side,90 degrees to bench top.flush with bench top edge,and just let the assembly hang off the side.I guess you could also clamp the stand upside down from whatever to get the clearance.Obviously this for center supported,not rails.
    Tom

    Comment

    Working...
    X