Announcement

Collapse
No announcement yet.

Identify this early carb and manifold please

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Identify this early carb and manifold please

    Just picked up this carb and intake and would like to know what it fits, it is unusual with the external threads on the carb body. Thanks, Gary
    Attached Files

  • #2
    Cleaned up the mystery carb

    Hope this helps on my mystery carb.
    Attached Files

    Comment


    • #3
      1913 sears/dayton De Luxe v twin. Maybe. look around for a few photos on line.
      rob ronky #10507
      www.diamondhorsevalley.com

      Comment


      • #4
        Its delightful, whatever it is, Gary!

        Thanks for the pics for my library.

        Can you measure the manifold spigot thread pitch and diameter?
        They appear right hand?

        ....Cotten
        AMCA #776
        Dumpster Diver's Motto: Seek,... and Ye Shall Find!

        Comment


        • #5
          That's a Flying Merkel twin intake manifold, circa 1914. The bracket lugs support the compression release assembly.
          Eric Smith
          AMCA #886

          Comment


          • #6
            Yes I think 13 and 14 Flying Merkel twins, I found a good picture of a 13. Thanks all! Gary

            Comment


            • #7
              Originally posted by 34 cac View Post
              Yes I think 13 and 14 Flying Merkel twins, I found a good picture of a 13. Thanks all! Gary
              Can you get a thread count and spigot diameter for Posterity, Gary?

              I keep notes, Thanks...

              ...Cotten
              AMCA #776
              Dumpster Diver's Motto: Seek,... and Ye Shall Find!

              Comment


              • #8
                16 on the threads an 1.10 out side on the external threads hole in card by threads .94 and inside the manifold threads about 1.05. Gary

                Comment


                • #9
                  Originally posted by 34 cac View Post
                  16 on the threads an 1.10 out side on the external threads hole in card by threads .94 and inside the manifold threads about 1.05. Gary
                  1 1/8"-16tpi, Gary?

                  That's unique!

                  Certainly different than anything on this chart (Sorry I forgot who shared it... but thanks!)

                  The variety of early Schebs is incomprehensible, Folks.
                  One 1¼" HX crossed my benches that was 1¼" NPT.

                  I just figured out the little 3/4" NPT Hen carbs are actually 24mm bores.
                  Now I gotta change my float labels again.

                  ....Cotten
                  Attached Files
                  AMCA #776
                  Dumpster Diver's Motto: Seek,... and Ye Shall Find!

                  Comment


                  • #10
                    It is a right hand thread and a straight thread which takes a thin lock nut to keep it tight. It is the only carb I have seen with an external thread and it is built for the ported air sleeve as there are stops on the body for it and the stock air intake for the front of the carb falls in the body as it is bigger. Gary

                    Comment

                    Working...
                    X