Announcement

Collapse
No announcement yet.

67 Shovelhead 4 Speed

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 67 Shovelhead 4 Speed

    Does anyone know if there is a tool made to install a main drive gear shaft seal for 67 4 speed, as you know this is a small seal and difficult to get started straight. ? Or any advise on installing one. As always I appreciate the info.

    Thanks

  • #2
    With the exception of turning down a piece of round stock and making your own. I know of non. Just put a socket on it and have way with it. Bob L
    Last edited by Robert Luland; 08-19-2019, 07:39 PM.
    AMCA #3149
    http://www.thegoodoldmotorcyclepartscompany.com

    Comment


    • #3
      I always bought a couple extras when replacing that seal!

      Comment


      • #4
        PVC tubing.
        Robbie Knight Amca #2736

        Comment


        • #5
          I make seal installers on my lathe out of PVC like Robbie said.I take dimensions & go to hardware store & buy a pipe or usually connector & turn it down.The seal is supposed to be .050" in from face of case,so I make a step to set to right depth
          IMG_5797.JPG
          Last edited by duffeycycles; 08-20-2019, 08:04 AM.

          Comment


          • #6
            DF244591-AB48-4F3E-9E03-2D4AC3B3617A.jpgi use and ild 5 c collet

            Comment


            • #7
              Jims make a tool, #2256-1, but at around $100, you would need to use it almost daily to make it worthwhile.

              Comment

              Working...
              X