Announcement

Collapse
No announcement yet.

Help IDing Tool ??

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Help IDing Tool ??

    This tool was in a pile of parts I recently picked up. It was loose and missing the handle. Not in a marked bag. I've searched V-Twins, Drag. Spec., etc. and cannot find. It measures 4" long, 2.00 O.D., 1.400 for I.D. and measures approx. 0.750 center to center between each engaging tooth. Any ideas? I think it's a XL tool.
    Thanks,
    William
    Attached Files
    William Edwards, AMCA #10035

    Attend the 2019 Southern National Meet at Denton Farmpark, NC, 17-18 May 2019
    http://www.amcasouthernnationalmeet.com/

  • #2
    William!

    It looks like what I made for 45" clutch gear nuts.
    But flimsier.

    ...Cotten
    PS: I haven't used mine in so long, its full o' mud-dauber nests.
    Attached Files
    Last edited by T. Cotten; 05-23-2017, 03:46 PM.
    AMCA #776
    Dumpster Diver's Motto: Seek,... and Ye Shall Find!

    Comment


    • #3
      Cotten,

      Thanks for the info! I'm not up the 45's. I do like the outer ring on your rig for the extra strength sans mud-daubers!

      William
      William Edwards, AMCA #10035

      Attend the 2019 Southern National Meet at Denton Farmpark, NC, 17-18 May 2019
      http://www.amcasouthernnationalmeet.com/

      Comment


      • #4
        looks like 4 wheel drive front wheel bearing wrench, maybe Dodge
        Kevin Valentine 13
        EX-Chief Judge

        Comment


        • #5
          I wished it had been marked with a number or brand......
          William Edwards, AMCA #10035

          Attend the 2019 Southern National Meet at Denton Farmpark, NC, 17-18 May 2019
          http://www.amcasouthernnationalmeet.com/

          Comment

          Working...
          X