Tweet
Hello all. Does anyone have schematics for a vard fork axel? Or perhaps a loose one to measure? I believe that I have the correct lower leg caps but I have no idea what the axel looked like. Thanks. Burt in PA
NOTICE: New member email requirements now in effect. Longtime member having trouble logging in? Please review the requirements here.
Only registered users may post new messages on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. To start viewing messages, select the forum that you want to visit from the selection below.
If you are NOT an AMCA Member and would like to join Click Here